Linksys WAPPOE12 Manual de usuario descargar pdf (Pagina 8)

Chapter 2

Configuration

12 Volt Power Over Ethernet Adapter Kit

Power on a Device that Uses Inline Power

Use only the Injector to power up a device that supports

inline power. Follow these instructions:

Connect the Injector’s built-in Ethernet network cable 1.

to your router, switch, or other network device.

Connect the Kit’s included Ethernet network cable to 2.

the Injector’s Power & Data OUT port.

Then connect the other end to the Ethernet port of 3.

your remotely located access point or other network

device.

NOTE: If the plug of the Splitter’s Power cord

does not fit into your network device, then

use the included barrel jack adapter. Plug the

Splitter’s Power cord into the jack end, and plug

the other end of the barrel jack adapter into the

Power port of your network device.

Connect the Kit’s power adapter to the Injector, and 4.

plug the other end into an electrical outlet or surge

protector.

Congratulations! The installation of the Power Over

Ethernet Kit is complete.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sin comentarios

Linksys WAPPOE12 Manual de usuario Pagina 8