Linksys 0/100 LA N C a r d Manual de usuario descargar pdf (Pagina 31)

Linksys EtherFast Series

Windows NT 4.0 Installation &

Setup

Overview

The following instructions will set up the EtherFast 10/100 LAN Card in a

computer running NT 4.0 server/workstation. You should have your original

Windows NT CD-ROM handy during the installation, as you might be asked

to supply it. Always contact your network administrator or consult your NT

documentation if you have questions.

To install the network driver for an NT 4.0 Server or Workstation

1. Log into Windows NT as an administrator.

2. Click on Start, Settings, Control Panel, and then double-click on the

Network icon.

3. If you have not previously installed Windows NT networking on your

computer, a message will appear that reads: Windows NT Networking is

not installed. Do you want to install it now?

• If you see this message, click Ye s to install NT networking along with the

EtherFast Card's network driver, and continue with step 1 below.

• If you don't see this message, NT networking is already installed. Skip to

step 1 on page 34.

Installing NT Networking & the EtherFast Card Driver

1. After clicking on Ye s , the Network Setup Wizard window will appear.

2. Put a checkmark next to the Wired to the network option. Click Next.

LNE100TX v4 test doc.qxd 3/22/00 4:13 PM Page 28

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 73 74

Sin comentarios

Linksys 0/100 LA N C a r d Manual de usuario Pagina 31