Linksys LKG0F755E Manual de usuario descargar pdf (Pagina 2)

Installing the Network Storage Link and OneTouch Drive

Connecting the Network Storage Link to Your Network

1. Connect one end of an Ethernet cable to

the Ethernet port on the back of the

Network Storage Link.

2. Connect the other end of the Ethernet

cable to your router.

Figure 1. Connecting the Ethernet cable

Connecting the OneTouch Drive to the Network Storage Link

Important – Make sure that the Network Storage Link is turned OFF before you connect

or disconnect your Maxtor OneTouch drive!

3. Connect one end of the included USB

cable to your OneTouch drive.

4. Connect the other end of the USB

cable to the Disk 1 port on the Network

Storage Link.

Note: You can only connect up to two

drives. Do NOT connect additional drives

using a USB hub.

Figure 2. Connecting the USB cable

Powering Up the OneTouch Drive

5. Connect the round female connector from

the power adaptor to the drive’s power

connector

6. Connect the two-pin female connector on

the power cord to the power adaptor.

Figure 3. Connecting the power

7. Connect the standard 3-pin electrical plug to an AC power outlet (preferably a

surge-protected outlet).

8. Turn on the OneTouch drive using the switch on its back panel.

Powering Up the Network Storage Link

9. Connect one end of the power adaptor to the back of the Network Storage Link.

10. Connect the other end of the power adaptor to an AC power outlet (preferably a

surge-protected outlet).

1 2 3 4 5 6 7

Sin comentarios

Linksys LKG0F755E Manual de usuario Pagina 2